了解橡膠低溫回縮性能試驗機的測試原理及使用步驟
瀏覽次數:3758更新日期:2021-09-26
低溫性能是橡膠的一個重要參數。橡膠環境溫度的降低,使其性能上產生一個負面的影響。隨著環境溫度的降低,分子鏈的移動隨著減少。當降低到達一個穩定的溫度,分子鏈將不在移動并且橡膠將失去所有橡膠特性。橡膠將顯示脆性并變成類似塑料的性質,橡膠密封件的實際應用必須對這些低溫性能有一個很高的要求。橡膠低溫回縮性能試驗機是伸張后凍結的試驗片在慢慢升溫后測定其伸長回復率的試驗機。
測試原理是將待測試樣在是一定的溫度下進行拉伸,然后冷卻到在除去拉伸力時,被拉伸的橡膠不會(huì )出現回縮的足夠低的溫度,除去拉伸力,并已均勻的速率升高溫度,測定出規定回縮率時的溫度及溫度與回縮率的變化曲線。
橡膠低溫回縮性能試驗機的試驗步驟:
1.將試樣按選定的伸長值伸長, 固定其上、下限制器, 鎖住固定旋鈕, 使試樣伸長固定, 但必須保證試樣在標準室溫下的拉伸只持續一個短的時間。
2.將拉長的試樣及試樣架伸入冷凍保溫箱. 強制循環加入的冷凍劑, 使箱內溫度下降到相應的溫度, 然后松開固定旋鈕。
3.在等速升溫( 一般為1 ℃/m) 條件下讓試樣自由回縮。
4.在試樣回縮過程中, 每隔一定時間記錄一次試樣長度及其對應的溫度, 也可以采用自動記錄方法, 自動記錄溫度一回縮( TR ) 曲線。