精輝牌橡膠快速塑性計校準方法
精輝牌橡膠快速塑性計的試驗壓力由砝碼杠桿提供,試驗時間由PLC控制,模室溫度由PT100+溫控表控制,這三項已進行了出廠設定,使用中一般不會(huì )發生變化;試樣預熱時的厚度取決于壓頭、底盤的相對距離,這個距離必須準確到1±0.01mm,所以要進行校準,KS-W橡膠快速塑性計背面設有標定按鈕和上下按鈕,按下標定按鈕即進入標定程序,可以方便地對1±0.01mm進行校準標定。
精輝牌橡膠快速塑性計的校準主要包括試驗壓力(100N±1N)、試驗時間(15.0s±0.2s)、模室溫度(100℃±1℃)和試樣預熱時的厚度(1±0.01mm)。
精輝牌橡膠快速塑性計如圖:
掃一掃 微信咨詢
©2024 揚州精輝試驗機械有限公司 版權所有 備案號:蘇ICP備18016239號-3 技術支持:化工儀器網 sitemap.xml 總訪問量:313252 管理登陸
電話
微信掃一掃