橡膠塑料老化箱使用說明:
1、本箱應放置在室內干燥、無腐蝕性氣體環境中。
2、應配備并符合工作電壓及電氣安全要求的配電板供本箱使
用
3、必須要可靠接地。
4、待一切準備就緒,可放入試樣,關上箱門。接通電源,即可
401 A型 (200℃)
開啟“電源開關”與“加熱開關”。
5、溫度調節:按功能鍵“∩”約1秒鐘即可進入參數設定,上部排窗口顯示SP,按“▲”、“▼”,使下排顯示為所需要的設定溫度。時間調節:繼續再按“∩”鍵,上排顯示ST,按“▲”、“▼”鍵,使下排顯示為所需要的定時時間,再按“∩”鍵,回到標準模式。(按▲∕TIME鍵,查看已運行的時間。)
6、控制參數改變方式,按“∩”鍵4秒鐘以上,再按“∩”鍵,找到LK,按“▲”、“▼”鍵,使下排顯示為18,再按“∩”
鍵,找到所需要調整的控制參數的提示符,按“▲”、“▼”鍵,使該控制參數顯示為所需要的值。幾個控制參數可以一次調整完畢,再按“∩”鍵4秒鐘以上,回到標準模式。(不按1分鐘自動回到標準模式)。出廠參數已經調整好,請不要改動(除超溫設置)。
7、超溫設置,按住“∩”鍵4秒鐘以上,再按“∩”鍵選擇到LK,按“▲”、“▼”鍵,使下排顯示為18,再按“∩”鍵,
選到上排顯示CL,再按“▲”、“▼”鍵選到要超溫的參數(例如:當溫度超過SP+CL數值時,報警燈亮,COL)。就是如SP設置為100℃+CL設定為5℃,當溫度超過105℃就輸出報警。
掃一掃 微信咨詢
©2024 揚州精輝試驗機械有限公司 版權所有 備案號:蘇ICP備18016239號-3 技術支持:化工儀器網 sitemap.xml 總訪問量:313252 管理登陸
電話
微信掃一掃