打包帶拉力機測量標距的*方法:
手動測量就是在夾持器移動桿邊豎直設置一根標尺和兩根可在豎直方向上移動的水平標距桿,拉伸試驗時,靠目力觀察試樣上標距的變化,手動控制兩根標距桿,使之與試樣上的標距同步,同時記錄標距桿在標尺上的移動距離。手動測量的誤差非常大:其一,目力觀察試樣標距會(huì )引起一定的偏差;其二,靠手動移動標距桿始終無法準確跟蹤試樣標距變化;其三,試驗人員一邊移動標距桿,一邊很難記錄標距值,更無法在試驗結束后準確描述應力-應變曲線。相比較自動測量標距更有利于對橡膠拉伸性能的檢測?,F在很多打包帶拉力機的自動標距測量裝置采用接觸式傳感器即時測量標距的變化,傳感器移動裝置的安裝位置主要有兩種:①安裝在夾持器;②試樣上。將移動裝置安裝在夾持器的傳感器有一定的局限性。由于橡膠的彈性變形非常大,夾持器的移動距離和試樣標距的變化值有很大的差距,所以安裝在夾持器上的標距傳感器比較適合檢測彈性變形非常小(如金屬材料)試樣的拉伸性能,而不能用于檢測橡膠拉伸性能。采取接觸式標距測量方式對試樣拉伸試驗會(huì )產生很大的影響,影響原因如下:其一,接觸試樣的標距桿的自重會(huì )將試樣向下扯,影響拉力測量;其二,標距桿的夾持對被夾持部位的拉伸有一定的影響,使其不能自由拉伸。
掃一掃 微信咨詢
©2024 揚州精輝試驗機械有限公司 版權所有 備案號:蘇ICP備18016239號-3 技術支持:化工儀器網 sitemap.xml 總訪問量:313252 管理登陸
電話
微信掃一掃