應重視硫化儀在保養過程中的安全守則
瀏覽次數:2324更新日期:2018-03-06
硫化儀是橡膠加工行業控制橡膠質量,快速檢驗及橡膠基礎研究應用zui廣泛的儀器,為橡膠*化配方組合提供了的數據,可測出焦燒時間、正硫化時間、硫化指數及zui大、zui小轉矩等參數,我們在使用硫化儀一段時間后都要去維護此設備,那在我們維護的過程中應該注意那些事項呢?以下就由小編為你詳細的介紹一下吧
硫化儀的維護保養時應注意以下問題:
1、硫化儀存放環境應保持干燥、通風良好,避免因潮濕導致電器線路潮濕;
2、不要在雨天在室外使用硫化機,防止電控箱及加熱板進水;
3、如果工作環境潮濕、多水,在拆卸搬運硫化機時,應在地面用物品墊高,不要讓硫化儀同水直接接觸;
4、如果在使用過程中,因操作不當導致加熱板進水,應首先廠家進行維修。如果需要進行應急搶修,可將加熱板上蓋板打開,先將水倒出,然后將電控箱設置為手動操作,加溫到100℃,保持恒溫半個小時,將線路烘干,在在手動狀態下進行皮帶膠接。同時應及時生產廠家,進行線路的整體更換。
5、硫化儀在較長時間內不需要使用的情況下,應每隔半個月對加熱板進行加熱(溫度設置在100℃),保持溫度半個小時左右。
6、每次使用結束后,應當將水壓板內的水放干凈,尤其是冬季,如果水不能放干凈,往往導致水壓板膠皮過早老化,水壓板使用壽命降低;
想了解更多硫化儀的相關信息,咨詢